Glacier water cooler manual

Your installer must read the instructions in the manual! The Glacier Pool Cooler is not installed like a heater. The cold water leaving through the outlet line should be plumbed either into the SUCTION side of your pool pump, or into a designated line (as . Unplug (Figure 14) and approach the cooler from the front. 2. Remove the water bottle (Figure 15) and drain water from the reservoir and hot tank, remembering to cool and drain hot tank. Allow 1 hour for hot water to cool down inside the hot tank before removing the drain plug at the rear of the cooler to drain into a bucket (Figure 16 and File Size: 2MB. GLACIER POOL COOLERS, LLC PO BOX SCOTTSDALE, AZ () WARNING When pool equipment is located below the pool surface, a leak from any component can cause large scale water loss or flooding. Installation MUST have automated valves. Glacier Pool Coolers, LLC cannot be responsible forFile Size: 1MB.

9. Always unplug the water dispenser before servicing or cleaning it. nOTe: Your Glacier Bay water dispenser is designed with a special "safety" feature (low water level sensor) that controls Regular cleaning of your water dispenser is required for your activation/operation of the kettle feature hot water tank warranty. Page 3: Warranty. Product Description. Crystal Mountain - Glacier. Consistency in performance, competitive pricing one piece blow-molded cabinet of high-density polyethylene with UV resistance additives make this cooler a popular life-long unit. Dispenses degree water from one spigot and ice cold water from the other. Also available in white. Save energy and money while enjoying great-tasting water with Glacier Bay VWDBLS-1HDC Bottom Load Water Dispenser. This water dispenser features easy-to-use push button controls and dispenses your choice of hot, cold and room temperature water. Its patented kettle feature uses 70% less energy than traditional water dispensers and gives you hot water in under three minutes.

1. Place the water cooler on a flat level surface in a cool shaded location near a grounded wall outlet. Position water dispenser so that the back of the unit is a minimum of 2 inches / 5cm away from the wall to ensure proper ventilation.(Figure 1) 2. Place the water bottle on top of the cooler appropriately. For open reservoir models, the. Always unplug the water dispenser before servicing or cleaning it. nOTe: Your Glacier Bay water dispenser is designed with a special “safety” feature (low water level sensor) that controls Regular cleaning of your water dispenser is required for your activation/operation of the kettle feature hot water tank warranty. Glacier. Service Manual--Glacier (Bottled Water Cooler) V for E or S Reservoir. 1. Product Specification. 2. Parts Listing and Exploded Views.. Glacier Series Parts Listing.